Budapest, XIII. Ker. Lehel u. 54. (Kartács u. sarok) Tel.: 06-20 988 13 13

Belépés / Regisztráció
Kosár   [0]
Hengerűrtartalom (ccm)

  1 2 3 4 ... 179 180 181  


12V socket for tankbags with
DIN-angle plug, cable length: 1m

This cable enables you to charge various devices inside your tank bag via a 12 V cigarette lighter socket. The socket is powered via a 1 metre cable with a 12 V flat, angled vehicle plug, which plugs into the small DIN standard vehicle socket on your motorbike. The cable is fed into the tank bag using a cable gland.


  • 12 V Euro or cigarette lighter socket to provide a power supply inside the tank bag
  • 12 V flat, angled vehicle plug for connecting to your motorbike's small DIN standard vehicle socket
  • Cable length: 1 metre
  • incl. Cable gland for feed-through into the tank bag


  • 12 V cigarette lighter socket with power cable (length: 100 cm) and 12 V flat, angled vehicle plug
  • Cable gland
7 000 Ft (5 512 Ft + ÁFA)  


12V socket with termianls
and compact plug 2,50 Meter

12V Euro socket with battery terminals and compact plug

For connecting an electrical device (e.g. mobile phone charger, radio etc.) with a 12 V cigarette lighter plug. Also suitable for charging the bike battery. The socket is connected to the battery by means of battery clips. The total length is 2.5 meters.

Components supplied:

  • Cable with 12 V Euro socket
  • Fuse (10 A)
  • Connecting plug with battery clips

IMPORTANT: Not suitable for jump-starting.

4 550 Ft » 2 100 Ft (1 654 Ft + ÁFA)  


Bucheli Reparaturanleitung
Zweitakter, Technik-Sonderband 6005

Two-stroke engines - Engine . Carburettor . Ignition . Chassis

  • Two-stroke motorbikes are here to stay - the arrival of four-stroke engines has not driven them out.
  • This special edition of repair manuals contains all you need to know about the professional care, service and repair of the two-stroke engines found in everything from small motorcycles to vintage machines.
  • Choosing the right engine oil and spark plugs, cleaning and adjustment of carburettor, changing cylinders, pistons and crankshaft: no question goes unanswered. And it covers an amazing number of bikes that you can meet on the road.
  • A must for all two-stroke fans
  • 176 pages, paperback
  • Only in german language
12 220 Ft (9 622 Ft + ÁFA)  


FixItEasy 3-In-1 Holder
For Motorway Riding And Parking

3-in-1 holder for motorway riding (Austria) and for parking (Germany)

Exclusive available at Louis. Holder for vignette (approved by the Austrian motorway authority ASFINAG V4), parking disk or pay-and-display parking ticket

This innovative holder for the vignette (toll sticker) required on Austrian motorways will not damage your paintwork or bike. Much easier than having to attach and remove the sticker from your bike, and no risk of scratched paintwork. Once it is fixed in place, the mount cannot be transferred to another vehicle, so it complies with Austrian regulations.
Dimensions: 6.9 x 6.7 cm

Once fitted to your motorbike, the vignette holder also enables you to attach the parking disc/ticket holder supplied in the set for use in designated parking areas in Germany.
Dimensions: 11.0 x 15.0 cm

Installation instructions

  • Austrian motorway vignette:

Feed the holder strap around the fork/steering stem (front fork only) and pull tight. Use a screwdriver or similar tool to ensure that the strap is fully tightened and locked in place, rather like a cable tie. Cut off the projecting strap as close to the fork as possible,
e.g. using side-cutters. Then stick the vignette to the mounting plate, which must be free of dust. Make sure that the vignette is well centred and the expiry date is clearly visible.

  • For use as a parking disc/ticket mount (D):

Set the time on the parking disc using the arrow (24-hour scale), and secure the disc in the double snap catch via the slide system on the rear.
If you wish to use the mount purely for pay-and-display parking tickets, the parking disc can be removed again by lifting up the two clips and pulling it off from the bottom upwards. Then place your ticket under the window supplied with the mount; fit the window over the bottom edge of the holder and snap it over the top edge.

The parking disc itself is only suitable for use when the vehicle is stationary. Do not use it while riding.

5 250 Ft (4 134 Ft + ÁFA)  

33 OHM

Kellermann 33 Ohm Resistor

33 ohm resistor

On motorcycles that have a bulb indicator lamp (some BMW models), it may be necessary to fit both this resistor and a 7.5 ohm resistor (connected in parallel with the tail light and brake light circuits) in order to prevent the indicator lamp from lighting up unecessarily.

2 080 Ft (1 638 Ft + ÁFA)  



Universal 5-way switch, chromed.

3 500 Ft (2 756 Ft + ÁFA)  


Test Lamp 6-24 V

This test lamp is a very inexpensive yet invaluable tool. It detects faults in wiring harnesses and can be used for ignition timing with contacts. Can prove extremely useful when touring, so it definitely belongs in your travel tool kit.

  • 6 - 24 V
  • Recommended for any travel tool kit
1 750 Ft (1 378 Ft + ÁFA)  


Resistor with cables

Resistor with cables

Simply connect the ready-wired resistor using the male and female snap connectors, and the flashing frequency will be correct again!

  • 7.5 Ohm (corresponds to approx. 19.2 W)
  • For converting conventional 21 W turn signals to LED turn signals rated at, for example, only 1 W
  • Incorrect connection is not possible!
  • Simpl, parallel connection of the resistor
  • One resistor must be used for each turn signal
  • Suitable for almost any motorcycle model

For all LED turn signals!

2 800 Ft (2 205 Ft + ÁFA)  



Resistor with cables

Simply connect the ready-wired resistor using the male and female snap connectors, and the flashing frequency will be correct again!

  • 8.2 ohms (corresponds to approx. 17.6 W)
  • For converting conventional 21 W turn signals to LED turn signals rated at, for example, only 1 W
  • Incorrect connection is not possible!
  • Simple, parallel connection of the resistor
  • One resistor must be used for each turn signal
  • Suitable for almost any motorcycle model

For all LED turn signals!

2 800 Ft (2 205 Ft + ÁFA)  


Amennyiben nem szerezhető be a kívánt papír töömítés, magad is kivághatod.

A letsztított felületet tintapárnához nyomva a szükséges formát gyakorlatilag rá tudod pecsételni a tömítőpapírra. A kivágás már csak apró kézügyességet igényel.


Hengerfejtömítésnek nem használható.

  • méret: 50 x 50 cm
  • vastagság: 0,5 mm
3 500 Ft (2 756 Ft + ÁFA)  


Acebikes Loading Ramp
alum., max. load 340 kg

When you need to load your motorcycle onto a trailer or transporter and there's no loading ramp available, that's when the folding aluminium ramp from Acebikes comes to the rescue. The sturdy design, high-grade aluminium and light weight make this a super product. Special plastic parts help to prevent scratches or other damage to your machine. And for extra safety, a lashing strap is included for securing the ramp.


  • High-grade aluminium
  • Max. load 340 kg
  • Unfolded length: 114 cm
  • Open length: 220 cm
  • Width: 31 cm
  • Weight: 7.3 kg

Incl. Securing strap

42 000 Ft (33 071 Ft + ÁFA)  


Acebikes Bike-A-Side
Motorcycle Mover

Have you ever lifted something weighing hundreds of kilos and manoeuvred it in every direction as if it were as light as a feather? Impossible, you might say. But, in fact, it's no problem at all! At least not for Acebikes, because their engineers have come up with something very special, once again.

Namely, the Acebikes Bike-a-side motorcycle mover for large bikes weighing up to approx. 450 kg! A fantastic thing to have in any workshop or garage - easy to use wherever space is too restricted for "normal" parking.

The Bike-a-side couldn't be simpler to use. Ride your bike's front wheel onto the motorcycle mover, or push the mover under your bike from the side. Then simply put your bike on its centre stand and raise it using the side-mounted lever. The 65-mm ball bearing-mounted heavy-duty wheels allow you to comfortably manoeuvre your motorcycle and park it in places with difficult access.

Bike-a-side in detail:

  • Makes it easier to lift and move your motorcycle
  • Lightweight and very durable construction
  • Comfortable, controlled lifting and lowering with the lever
  • 4 x 65 mm smooth-running heavy-duty wheels with ball bearings allow manoeuvring in all directions
  • Also suitable for use on uneven surfaces
  • For motorcycles weighing up to 450 kg
  • Very grippy bottom surface for fast and reliable braking

Material: steel
Net weight: approx. 16.5 kg
Dimensions (L x W x H): approx. 49 x 85 x 10 cm

Important: We recommend always having a second person to assist you when using the Acebikes Bike-a-side, but with a little practice, it can also be used single-handedly.

77 000 Ft (60 630 Ft + ÁFA)  


Acebikes Carry Bag
for loading ramps

The optimal carry bag for storing and transporting your loading ramp.

  • Material: Textile
  • Colour: Black
  • Weight: 0.66 kg
  • Dimensions: (LxWxH) 120x17x32 cm

Suitable for loading ramps 10010059 & 10002798

7 000 Ft (5 512 Ft + ÁFA)  

Acebikes lashing hook set

Acebikes lashing hook set
D-ring, 4 pcs

If you're looking to equip your van, pick-up or trailer to make it easier to transport your motorbike or other vehicles, what you need is some good anchoring points for the hooks on your lashing straps. The set of 4 D-rings from Acebikes does the job perfectly. Bolted down on any rigid surface, together they will hold 550 kg securely. And basically for ever. After all, each D-ring and plate is electroplated and galvanised.

  • Load capacity: 550 kg
  • Dimensions: (L x W x H): 7 x 4 x 1 cm
  • Material: Galvanised steel
  • What you get: 4 D-rings with plates, incl. 8 hex bolts (M6 x 25 mm) with lock nuts and 16 washers.
3 500 Ft (2 756 Ft + ÁFA)  


Acebikes Lashing rails
2 Pieces Incl. Carabineer

ACEBIKES Transport Tie-Down Rail Set

Secure your motorbike on your trailer or in your van so that it will not move an inch.

These sturdy tie-down rails, made of galvanised steel, are bolted permanently, left and right, to the floor of the transport vehicle or trailer, enabling you to attach lashing straps securely and with variable positioning.


  • 2 tie-down rails
  • Each rail is 80 cm long
  • 4 carabiners
  • Incl. fittings
17 500 Ft (13 780 Ft + ÁFA)  

  1 2 3 4 ... 179 180 181